ESOS Helpline
+86-400-7800-328Telephone：+86178-5219-8088 / +86198-1906-9099
ESOS Helpline
+86-400-7800-328The operating system of the cutter suction ship mainly includes the large arm of the reamer, which realizes the stirring of the bottom sludge by controlling the lifting and moving of the reamer. At the same time, the movement and the amount of work can be controlled by controlling the speed of the reamer head, the screw propulsion and the lifting of the fixed pile. So how to achieve the operation of the winch suction boat?
① The rise and fall of the big arm of the reamer head should not be too fast, so as not to get the reamer stuck in the mud by its own gravity.
② To start the reamer head, it is necessary to start the reamer head when the big arm is gently placed on the bottom and no longer sinking.
(3) It is necessary to often clean the garbage at the suction pipe entrance of the cutter suction boat, and the general inlet is equipped with a filter net, which is easy to be blocked by some debris, resulting in a significant reduction in the flow rate of the slurry pump and affecting the work efficiency.
④ Cutter suction boat for dredging work, generally with fixed piles, fixed piles are located at the tail of the hull, after the completion of the work when lifting fixed piles must pay attention to speed, speed must not be too fast, especially small cutter suction boat, fixed pile position near the main engine room, too fast speed is easy to cause the hull tilt main engine room water, the whole dredger will sink.
|
Previous:The use of dredgers
Next item:NO！ |
Return to List |
